html=filename : Same as "-txt" except it generates the html report. txt=filename : Launch CPU-Z in ghost mode (no interface appears) and generates the register dump file (.txt) CheckUpdates : set to 0 to disable the new version checker at startup. Your system won't be fully validated before it is manually checked. XOC : eXtreme Overclock Mode : runs CPU-Z with as little system load as possible. Chipset : set to OFF (or 0) disables the memory controller and southbridge information. BusClock : Set to 1, uses the bus clock as primary clock source. UseDisplayAPI : Set to 1, uses the display driver to read the display adapters information. Display : Set to OFF (or 0) disables the video card information reported in the validator. ![]() SMBus : Set to OFF (or 0) disables SMBus information : SPD, and, depending on the hardware, sensoring information. This concerns BIOS vendor and version, motherboard vendor and revision. DMI : Set to OFF (or 0) disables the DMI (Desktop Management Interface) information. MaxPCIBus : Sets the maximum PCI bus to scan. This disables chipset, SPD and, depending on the hardware, sensoring information. PCI : Set to OFF (or 0) disables the PCI information. Sensor : Set to OFF (or 0) disables sensor chip detection and voltages measurement. LabelFontSize : Size of the font used for the label boxes. LabelFontName : Font used for the label boxes. Value is expressed in hexadecimal, and consists in a classic Red/Green/Blue color code : RRGGBB ![]() TextFontColor : Color of the font used for the information boxes. TextFontSize : Size of the font used for the information boxes. TextFontName : Font used for the information boxes. The configuration file must be named cpuz.ini and be present at the same directory level
0 Comments
Leave a Reply. |